SimConMOTION Software
Download Drivers from SimConBASE page.		 V1.1 Eng@Updated on 2005.09.28
Click "SimCon" Desktop icon once.
Click Icon on taskbar when proceed to set up menu.
Click "Test" Button.
The controller will begin correspond signal with each actuator cylinder when power supply is switched on first time. It may takes a few minutes.
Tips: Click and drag slider point of "Tachometer" to activate both cylinders quickly by Test mode.
Cylinder move by Click & Drag pointer on slider bar.
Upper = Seat tilt to forward
Under = Seat tilt to backward
Left = Seat tilt to Left
Right = Seat tilt to Right
and combined XY position.
Slip effect
Vibration generate when lock up front tire. ON/OFF can do by check box. Nothing happen anti lock brake mode in game.
Setting
 The following setting menu will appear by "Setting" button is pushed.
G Force Setting

neutral position(vertical)
Setting for front / back 0 position.

horizon width
Adjustment of left / right side moving width.

vertical width
Adjustment of front / back moving width.

speed (high)
Adjustment of motion speed.		 Vibration filter
You can select from following 3 modes.

Pure@G
Motion move according to raw G information from game directly.

Threshold
In PureG mode, a fine/small vibration is unpleasant and there is a case when you want to decrease vibration depending on the a type of car, a suspension, and a road surface. The size of G change is divided into five steps, the G change size and each speed of operation are set up with the slider. It is possible to move slow a fine/small vibration and make big G change move quickly

Vibe Cut
This is the mode which vibration cut mode and operates according to only big G change. The moving speed is follow to the speed on left menu "speed (high)", since a speed of operation is fixed, please adjust speed by the type of a car, a category, etc. For example, set to speed 3000 to about 4000 in GT car, and about 6000 in F1. It will become not smooth movement if it sets up too high value.

Custom
This is the pre-set of your favorite set up.

Those default value can be changed at Program Files> FrexGP>FrexGP SimConBASE Controller > RaceSim.ini
Slip Effect Setting
Wave width
Adjustment of wave width.
wave speed
Adjustment of wave speed.

average and vibration cut
Those are the value for "Vibe Cut" mode only.
Set both value to 0 when operate under other modes.
A game will be good to make a minimize by "Window Mode" or minimize by Alt+Tab key and change setup until setup of liking is decided.
www.frex.com/gp/
2005- FREX All rights reserved.