 |
FrexGP SimConMETER Multi-functional and highly-functional meter will bring you to another level of racesim environment. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| FrexGP SimConMETER On screen information in racesims is useful, but lacks reality. SimConMETER was developed for all racesim fans who cannot be satisfied with the meter displayed on the screen. By reading information required for driving in actual meter, it also means you're enable to drive without a cockpit image on your monitor. The monitor only needs to show the image outside of a car, just like a scene when you get into the car, read information from a real meter and look outside the car through the windscreen. More real simulation environment can be realized with the construction of the perfect virtual simulator environment, like projection of the racesim to a huge screen with a projector/beamer. SimConMETER make such a virtual driving simulator possible. SimConMETER also contributes to the improvement of the framerate by excluding unnecessary elements from the complicated cockpit. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 SimConMETER+MOMO Model 101 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Functionalty: - A warning is displayed when oil or water temperature reaches a certain value. - It will remember the peak rev from the engine's highest rpm. - The top speed peak hold function is effective when changing a gear ratio and aero setup. - A warning will be displayed when fuel level reaches a value below settings. This will be useful to prevent you're out of fuel, or with pits stop strategies. Easy shift light setting function: Blink LED upper than the engine rpm when you push to set the Red button switch long. Six steps LED allows automatically set subtracted each 250 rpm at same time. It is also possible to set up each rpm point manually, of course. Setup will be done by using two buttons: A: Black Upper Button = Select B: Red Bottom Button = Confirm A: Switch between analog or digital display mode A B: Set up mode - Select between 2 displays from Oil Temp, Water Temp, Fuel - Set warning numerical value and select LOWER or UPPER(CH2) - UPPER : warning when beyond the value for temp. - LOWER: warning when below the value for fuel. Set up maximum rpm. 20,000 rpm is the maximum value. Adjust brightness of shift lights. B: Cancel Warning Technical Note: SimConBASE is needed to work properly. DC power DC9V to DC16V is required. Connect 2 wires [DC+ Orange or Red ][ DC-Negative Gray or Black] to DC adapter. Connection cable to EXT. of SimConBASE or SimConMOTION is included. approx 2.5m Case size: W150xH50xD35mm Stand is not included. Mount by two metric size 4mm knob bolts on back. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2006.04.25 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| © All reserved 2006- FREX www.frex.com | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||